//assets.cakeresume.com/assets/contentarea/contentarea-2d64eca8dae2a1ffb31e0fb1df887bbad072c7c19734d7d30fa14884bbcc299a.css

乙級電腦輔助機械製圖技術士

勞動部

丙級電腦輔助立體製圖 

丙級化學技術士

Thesis : Study on Cracking and Delamination in Polymer Coating s of Cardiovascular Stents

In this study, Finite element analysis (FEA) was performed to simulate the stress response of two commercial stents, Xience V (Abbott Vascular) and Resolute (Medtronic Cardio Vascular), during compression and expansion, and to investigate the association with the defects of stent coating. In the following, the strain distribution of magnesium alloy stent coating during the stent compression, expansion and bending was analyzed in relation to the stent degradation rate using FEA. Then, the mixed model of Cohesive Zone Model (CZM) was used to investigate the adhesion and separation mechanism of a stent-coating interface during compression and expansion. Finally, a conventional V-shaped polymer coated stent was manufactured. The adhesion and separation phenomena between the stent and coating was investigated by expanding the stent progressively, and the experimental result was compared with simulation.




National Taiwan University of Science and Technology

Senior Project:Micro-motor center Harmonic Drive moped gearbox design(Patented in 2020 TWI694952B)

This study is aimed at electric mopeds, which previously weren’t having any improvements due to the weight and volume of the reducer. This study proposes replacing the original reducer with harmonic gears. The high efficiency of the high-speed motor can improve the overall efficiency by the high gear ratio of the harmonic gear.

National Formosa University (NFU)

江宜欣 I have over five years of experience as an UI/UX designer. By incorporating data analysis and user interview, I have assisted many businesses i...

江宜欣

工業技術研究院 (工研院，ITRI)

實習生

Institutional Design Analysis

1. Assisted in the design and development of human-like dual-arm robots 

2. Improved and analyzed design and the structure of fingers 

3. Participated in project discussions and schedule planning with the team 

4. Contributed to the improvement of Supplier Design and Manufacturing

Human-like two-arm robot
https://www.youtube.com/watch?v=MDDdPlWyiDw

江宜欣’s posts