//assets.cakeresume.com/assets/contentarea/contentarea-2d64eca8dae2a1ffb31e0fb1df887bbad072c7c19734d7d30fa14884bbcc299a.css

An individual has an experienced in Power Generation  and also have strong knowledge in the circuit and current discharge. Interesting to apply my knowledge in electrical engineering roles to achieve an individual objective which is parallel with an organizational objective.


Mehran university of Engineering and Technology Jamshoro

Electrical Engineer(B.E)

Hamza Imdad

Yunus Textile Mills Nooriabad (YTM-06)

Assistant Shift Engineer

    "YUNUS TEXTILE MILLS, NOORIABAD"

AT 12.48MW POWER HOUSE(UTILITIES):

. Responsible for maintaining daily Power Generation & Utilization reports of Gas Engines and Air Consumption reports of Compressors.

. Responsible for the Operation and Maintenance of 5 Compressors [BOGE S100-2, GD-ESM 55, GA-90VSD & two ZR-315 Compressors].

. Responsible for the routine & preventive maintenance of Compressors, Heat exchangers, 3-phase pumps, dryers,cooling towers, Exhaust fans, Supply fans, bus bars, panels etc.

. Hands On Experience of the Installation of Automatic Voltage Regulator (AVR) to overcome the fluctuations of Voltage from Main Grid (connected with HESCO supply).

. Hands on Experience of the Installation of Transformers, MTU gas Engine, and Transmission of underground Cables etc.

. Responsible for Visiting the Engine Hall on daily basis to monitor the Operation & Maintenance of Gas Engines & questioning to the duty staff to get the basic information about the Operation & Maintenance of Gas Engines [ JGS-320, JGS-420, JMS-612, MTU, CAT3520E, CAT3520C × 2 & Waste Heat Recovery Boiler (WHRB)].

分享